10 FOOT TALL ALUMINUM PIPE AND DRAPE VERTICAL UPRIGHT WITH SLOTS AT TOP & 3 FEET

Description: 10 Foot Upright for Pipe And Drape Kits! What's Included In The Listing:One 10 foot high (120"H) break apart upright. Listing is for the upright only. Additional hardware sold separately in our eBay store. About The Upright:This durable aluminum upright sets the height of your pipe and drape display, and is the vertical piece of pipe that is located at each end of a horizontal drape support rod. Two pieces of pipe work together to make a 10 foot upright in this break apart system. A 6 foot section serves as the bottom of the upright and is put on the base, and a 4 foot 4 inch section serves as the top piece. The 4" portion, located at the bottom of the 4 foot piece, has a slightly smaller diameter and simply slips inside of the top opening of the 6 foot bottom piece, as shown in the listing photo. The break apart upright system satisfies two objectives: one is that it allows the upright to be shipped by Ground service, saving you a lot of money compared to having a fixed (non-break apart) 10 foot upright shipped because any box over 8 feet has to be shipped on a freight truck -- which can be very expensive! Secondly, having a break apart upright makes transportation much easier, as the biggest piece of the upright is only 6 feet long. This will fit in most vehicles, whereas a 10 foot fixed (non-break apart) pipe is virtually impossible to fit, or safely transport, in most vehicles. IMPORTANT: Because it consists of two pieces (rather than one solid piece like our fixed uprights), the break apart uprights have a bit more wiggle room compared to our fixed uprights. This degree of wiggle can be significantly minimized by ensuring that the spacing between your uprights and drape support rod is correct when setting up your display. The height, when both pieces are together is 10 feet (or 120") tall, and the diameter is 1.5". This is a Slip-Fit upright, as it is hollow and is meant to be placed on top of a pin that is screwed on to a base (base and pin sold separately). There are 4 slots cut out at 90 degree angles at the top of the upright, at 8 feet high, and again at 3 feet high (the 3 foot and 8 foot cut outs are used if making trade show booths with a 10 foot tall back wall and either 3 foot tall or 8 foot tall side walls). These slots act as the entrance point for the hooks in our drape support rods to go in to. Because there are 4 slots, you can create a variety of display set-ups; in-line/linear, "L shaped", "T shaped", open ended boxes, and fully enclosed boxes. NOTE: Each end of a horizontal drape support rod will ALWAYS need an upright to hold it up. NOTE: If also purchasing a base from us (base sold separately), the recommended size and weight for this 10 foot tall upright is our 18" x 18" base that weighs 17 lbs. An upright must ALWAYS have a base underneath to support it. IMPORTANT: Use of products are intended for indoor, decorative use only. They should never be used where tip-over may cause injury or damage. Failure to use these products as intended will likely affect the safety of the products used and can result in injury or damage for which we are not responsible. Any box that is delivered, or component piece within a box, may be sharp, and should be handled with care. Additional Information: We answer any and all questions as quickly as possible. Our staff is available to assist you Monday - Friday from 9:00 am to 5:00 pm EST. We also sell all component pieces separately if an entire kit is not needed. Please contact us for more information.

Price: 49.99 USD

Location: Marietta, Georgia

End Time: 2024-11-05T18:51:11.000Z

Shipping Cost: 22.99 USD