2.5u microns 99.1% Aluminum Foil Ribbon Microphone Replacement Upgrade Mod

Description: 2.5µm Aluminum Foil99.1% 2.5µm (micrometer) Aluminum Foil sheet for damaged ribbons and upgrades.Why upgrade the ribbon to a 2.5µm ribbon? Most (not all) of the Chinese Ribbon microphones use 6µm aluminum foil which isn't as responsive as 2.5µm. Basically by lowering the mass of the ribbon you will increase the output voltage and frequency response slightly (a marginal increase, not much at all). SpecificationsThickness: 2.5µm (.00025 cm, .0025 mm, .000098 inches)Width: 6.25 cm (62.5 mm, 2.46063 inches) ***Length: 12.5 cm (125 mm, 4.92126 inches) ***Area (squared): 78.125 cm^2 (7812.5 mm^2, 12.10939 inches^2)Material: 99.1% Aluminum ***Tolerances: +/- 2 mm HANDLE WITH CARE. We are not responsible for the foil once you start handling it. The smallest burst of air can flip the foil over, bend it, or tear it. If you fold the material on accident you can smooth it out easily by putting it back in the tracing paper and running your fingers over the tracing paper until it is flat again TipsUse a cutting mat not a cutting board. You can find on amazon or a local hobby store.Make sure to clean the mat of debris to keep your cut nice and straight.Use a very sharp cutting tool (exacto).Cut slow and steady. Avoid starting and stopping.We like to keep the foil between the two sheets of tracing paper when cutting it to the desired width. This will help to avoid tear out on the edges. Buy some extra tracing paper to store the foil because every time you make a cut you will also cut the tracing paper and eventually run out of the supplied tracing paper.Use a flat ruler as a guide and apply enough pressure so the material doesn't move on you. Cut the ribbon to an over sized length. We like to cut a piece the entire length (longest dimension) of the raw material to make sure we can handle and install the ribbon properly.Have patience. It takes some practice. Try practicing on regular foil first to see how the material responds to cutting. You can also buy some 0.3µm-0.6µm imitation silver leaf to practice on. If you can cut this you will have NO PROBLEM cutting a thicker foil. Packaging We package the material between two pieces of acid free tracing paper. The material and tracing paper is then sandwiched between two pieces of thick poster board. Finally we ship the sheet in a non bendable mailer. Returns Returns are NOT accepted, BUT we will replace the material if it is damaged in transit. A few nicks in the material edges will not be considered damaged. This is normal for this thin of a material.International Buyers – Please Note: Import duties, taxes, and charges are not included in the item price or shipping cost. These charges are the buyer's responsibility. Please check with your country's customs office to determine what these additional costs will be prior to bidding or buying.

Price: 19.5 USD

Location: Arlington, Texas

End Time: 2024-08-15T20:57:49.000Z

Shipping Cost: 0 USD