Description: Crestron MC3 Controller Wireless Gateway USED VERY GOOD CONDITION INCLUDES POWER SUPPLY & ANTENNA Crestron MC3 Controller The Crestron MC3 is an economical 3-Series Control System® in a compact form factor with built in infiNET EX® wireless technology and on-screen display capability. Featuring the 3-Series® control engine, the MC3 forms the core of any modern networked home or commercial building, managing and integrating all the disparate technologies throughout the facility to make life easier, greener, more productive, and more enjoyable. Control Engine 3-Series®; real-time, preemptive multi-threaded/multitasking kernel; Transaction-Safe Extended FAT file system; supports up to 10 simultaneously running programsMemory SDRAM256 MB Flash2 GB External Storagesupports USB mass storage devices up to 1 TBWired Communications Ethernet10/100 Mbps; auto-switching; auto-negotiating; auto-discovery; full/half duplex; industry-standard TCP/IP stack; UDP/IP; CIP; DHCP; SSL; IEEE 802.1X; SNMP; BACnet®/IP[2]; IPv4 or IPv6; Active Directory authentication; IIS v.6.0 Web Server; SMTP e-mail client, installer setup via Crestron Toolbox™ or MSIE[4] Cresnet®Cresnet master mode USBSupports USB HID and USB mass storage class devices via rear panel USB 2.0 host ports, supports computer console via front panel USB 2.0 device port RS-232Supports 2-way device control and monitoring up to 115.2k baud with hardware and software handshaking IR/SerialSupports 1-way device control via infrared up to 1.2 MHz or serial TTL/RS-232 (0-5 Volts) up to 115.2k baud; supports CNXRMIRD IR Receiver[1]Wireless Communications RF TransceiverinfiNET EX® 2-way RF, 2.4 GHz ISM Channels 11-26 (2400 to 2483.5 MHz), default channel 15; IEEE 802.15.4 compliant Range (typical)150 ft (46 m) indoor, 250 ft (76 m) outdoor to nearest mesh network device(s); subject to site-specific conditions and individual device capabilities[5] Device SupportMaximum 100 infiNET EX devices (inclusive of up to 6 MTX-3 and/or MLX-3 remotes) and 5 infiNET EX expanders (model CLW-EXPEX or GLA-EXPEX)Graphics Engine (OSD) Built-in customizable control pages, scrolling menus, and dynamic objectsVideo (OSD) Output Signal TypesComponent (YPbPr), Composite Output FormatsProgressive 480p or 576p, interlaced NTSC or PAL Output Resolutions, Component720x480@30Hz (480i), 720x576@25Hz (576i), 720x480@60Hz (480p), 720x576@50Hz (576p) Output Resolutions, Composite480i, 576iAudio FunctionsAudio file playback, audio signal pass-thru w/mute during file playback Audio File FormatsWAV (8 & 16 bit PCM, mono & stereo, 8 – 44.1 kHz sampling rates), MP3, WMA Input/Output Signal TypesAnalog stereo Analog-To-Digital/Digital-to-Analog Conversion24-bit 48 kHz Performance (pass-thru)Frequency Response: 20Hz to 20kHz ±0.2dB; S/N Ratio: >93dB, 20Hz to 20kHz A-weighted; THD+N: <0.01%, 20Hz to 20kHz; Stereo Separation: >91dBConnectors AUDIO IN, L – R(2) RCA female, unbalanced stereo line-level audio input; Input Level: 2 Vrms maximum; Input Impedance: 7k Ohms nominal AUDIO OUT, L – R(2) RCA female; Unbalanced stereo line-level audio output; Output Level: 2 Vrms maximum; Output Impedance: 100 Ohms nominal VIDEO OUT, Y Pb Pr(3) RCA female, component (YPbPr) video output; Output Level: 1 Vp-p nominal (Y), 0.7 Vp-p nominal (PbPr); Output Impedance: 75 Ohms nominal VIDEO OUT, COMPOSITE(1) RCA female, composite video output; Output Level: 1 Vp-p nominal; Output Impedance: 75 Ohms nominal IR 1 – 5(5) 3.5mm mini-phone jacks, IR/Serial output ports; IR output up to 1.2 MHz; 1-way serial TTL/RS-232 (0-5 Volts) up to 115.2k baud IR IN(1) 3.5mm TRS mini-phone jack; For connection of the CNXRMIRD IR receiver[1]; Allows IR wireless control from Crestron and third-party remotes using RC-5 IR commands COM 1 – 2(2) DB9 male, bidirectional RS-232 ports; Up to 115.2k baud; hardware and software handshaking support LAN(1) 8-wire RJ45 jack; 10Base-T/100Base-TX Ethernet port USB 1 – 2(2) USB Type A female; USB 2.0 ports for storage and mouse/keyboard devices G(1) 6-32 screw, chassis ground lug RELAY 1 – 2(1) 4-pin 3.5mm detachable terminal block comprising (2) normally open, isolated relays; Rated 1 Amp, 30 Volts AC/DC; MOV arc suppression across contacts INPUT 1 – 2(1) 3-pin 3.5mm detachable terminal block comprising (2) programmable digital inputs (referenced to GND); Input Voltage Range: 0-24 Volts DC; Logic Threshold: ≥1.2 Volts DC active/high, ≤0.46 Volt DC inactive/low; Input Impedance: 2.2k Ohms pulled up to 5 Volts NET(1) 4-pin 3.5mm detachable terminal block, Cresnet master port; Outputs power to Cresnet devices if a power pack is connected to the 24VDC power input jack; Receives Cresnet network power if no power pack is connected to the 24VDC power input jack; See “Power Requirements” for additional specifications 24VDC 2A(1) 2.1 x 5.5 mm DC power connector, 24 Volt DC power input; PW-2420RU power supply included; Passes through to NET port to power Cresnet devices; See “Power Requirements” for additional specifications COMPUTER (front)(1) USB Type B female; USB 2.0 computer console port; For setup only Antenna (front)(1) Connection for supplied antennaControls & Indicators PWR(1) Green LED, indicates operating power supplied from power pack or Cresnet network NET(1) Amber LED, indicates communication with the Cresnet system HW-R(1) Recessed pushbutton for hardware reset SW-R(1) Recessed pushbutton for software reset ACQUIRE(1) Recessed pushbutton with red LED, used to set up connections with wireless devices ACTIVITY(1) Red LED, indicates wireless communications LAN (rear)(2) LEDs, green LED indicates Ethernet link status, amber LED indicates Ethernet activityPower Requirements Power Pack2.0 Amps @ 24 Volts DC; 100-240 Volts AC, 50/60 Hz power pack, model PW-2420RU included Available Cresnet Power35 Watts (1.46 Amps @ 24 Volts DC) when using power pack Cresnet Power Usage9 Watts (0.375 Amps @ 24 Volts DC) when using Cresnet network powerEnvironmental Temperature41° to 113°F (5° to 45°C) Humidity10% to 90% RH (non-condensing) Heat Dissipation31 BTU/HrEnclosure ChassisAluminum w/polycarbonate label overlay FaceplatePlastic w/polycarbonate label overlay MountingFreestanding (adhesive feet included)Dimensions Height2.30 in (59 mm); 2.25 in (58 mm) without feet Width8.12 in (207 mm) Depth6.74 in (171 mm) including antennaWeight 2.5 lb (1.2 kg) Additional Info: https://www.crestron.com/getmedia/b4f1af63-9015-4430-9984-b8d59dc47970/ss_mc3_1 * Includes only what is shown in pictures * If applicable, the current registration, calibration, licensing, software, programming, or preventative maintenance has probably expired on this unit by now. Buyer may need to reset or register this device, purchase licensing and/or software prior to configuration & usage * Please note that items are NOT included unless listed in writing or pictured such as: passwords, reset, device registration, programming, Unlock/Access/Key codes, software, drivers, speed controllers, power supplies, manuals, cords, etc.
Price: 120 USD
Location: Harvard, Illinois
End Time: 2024-10-18T23:20:21.000Z
Shipping Cost: 0 USD
Product Images
Item Specifics
All returns accepted: ReturnsNotAccepted
Brand: Crestron
Compatible Brand: crestron
Type: processor
Manufacturer: Crestron
Model: MC3
Compatible Model: MC3
MPN: MC3
Compatible Product: Adapter