DMX 512 Signal Tester and Lighting Terminator XLR 3-Pin

Description: You are bidding on one DMX Signal Tester & Terminator All in One DeviceOver 300 satisfied customers on this item aloneThousands of happy customers from the 9 items I hand make. Using a DMX Tester and Terminator will give you the ability to test if pin one or two is stuck in low voltage or high voltage it will also give you a visual of the DMX signal at the end of your signal path and after doing all of that it will still terminate the DMX signal. Signal Tester and Terminators are Ideal for Lighting Designers-Lighting Technicians-Bands-Churches-Mobile DJ-Schools-Clubs-TV studio DMX 512 Tester Manual The DMX 512 line tester displays the presence of the + Data and the – Data signals, when the tester is plugged into a DMX control line or feed-through connector. The LED will flicker an amber color when a DMX signal is present. If you have a solid Red LED then you have power but no DMX signal. Test 1: Plug the tester into the DMX line or feed-through connector to be tested. Once the lighting system is on, the LED should light. If the LED is red, then data – (pin 2) is stuck low. If the LED is green, then Data + (pin 3) is stuck low. If the LED is not lit then common (pin 1) may be open, both lines may be stuck low or no signal is being sent. Test 2: With the tester plugged in, fade all the dimmers from zero to full. LED should flicker at a different rate during the fade. If the LED is red and stays steady: data- (pin 3) may be stuck high. If the LED is green and stays steady: data + (pin 2) may be stuck high. If the LED is amber and is steady: both lines may be stuck high or the console may not be fading all dimmers. (Lines stuck high are usually caused by a failed driver circuits in the console, splitter, isolator, etc.) Note: Test 2 & 3 assume the DMX 512 signal is generated by a reasonably fast console. These tests may not work accurately with slow DMX 512 signals. Features 3-Pin Neutrik NC3MX Male XLR Metal Oxide Film Resistor which includes a non-flammable Coating Each Resistor used 1/2-watt 120-Ohms with 5% ToleranceTwo color LED Green LED data +Red LED - The LED will blink back and forth green and red, which will make it look orange Compatible with DMX512, DMX512/1990, DMX512-A, and RDM 100% quality control every piece is individually tested to DMX 512 Specifications Hand built by myself in the USA 60-day money back warranty. Once the item is shipped back. After 60 days I will replace with a new item for up to a year, Once the item is shipped back.

Price: 8.25 USD

Location: Kansas City, Missouri

End Time: 2023-09-11T04:56:41.000Z

Shipping Cost: 0 USD