Front Crank Wear Sleeve Installer Kit 303-761 for 2003-2010 Ford Powerstroke 6.0

Description: Fitment:Fit for 2003-2010 Ford Powerstroke 6.0L Features: (1)Replaces Motorcraft/OTC OE# 303-761. (2)Oil leaks from the front crank seal are a very common problem on the 6.0L Ford Powerstroke Diesel Engine. This tool kit helps install the delicate wear sleeve to the correct depth without any damage. (3)Radiator, fan and shroud removal is not required. It is nearly impossible to perform without an installation tool, this tool allows to perform a 3 hour job in 1 hour. How to Use 6.0L Powerstroke Front Crank Wear Sleeve Driver/Installer Kit Tool with Sleeve & Seal Begin by breaking loose the four front crankshaft dampener bolts. Then remove the belt. (The belt just needs to be slid off the upper idler pulley to allow enough slack to remove the crank pulley.) Finish removing the bolts and the front pulley. Fan, shroud, and radiator are shown removed for clarity, but removal is not required.Remove the five 10mm bolts that attach the oil pump cover and crank seal.With the cover removed, clean the oil from the area around the pump.Tape the area as shown with wide masking tape to prevent debris from getting into the pump gears.Use a small cut off wheel to carefully cut through the old wear sleeve (if present) and remove the sleeve.Clean the crankshaft - fine sandpaper may be required.Install the new wear sleeve into the tool and coat the inside of the sleeve with a light layer of red Loctite.Slide installer and sleeve onto crankshaftLightly tap installer with a hammer until it bottoms out.Remove installer - your sleeve is now installed to the correct depth. Remove tape, clean surfaces thoroughly, and apply some engine oil to the pump gears. Install new seal into pump cover and complete reassembly. Package included: Full Set Front Crankshaft Wear Sleeve Driver/Installer Kit

Price: 59.52 USD

Location: Walton, Kentucky

End Time: 2024-11-19T01:43:44.000Z

Shipping Cost: 0 USD