Laptop PC R43SG M.2 key M for NVMe External Graphics Bracket PCIe3.0 x4 Riser

Description: 1x Laptop PC R43SG M.2 key M for NVMe External Graphics Card Stand Bracket PCIe3.0 x4 Riser Cable for ITX STX NUC VEGA64 GTX1080ti （Cable in 25cm/50cm optional) Length is customizable,cable prices of different lengths are not the same,pls contact us if you need!Product name: PCIe x16 to M.2 M-key NVMe extension adapter for eGPUProduct model: R43SG/R43SG-TUTransfer speed: PCIe3.0 x4 , 32G/bps (Max.)Wire length: 25cm, 50cmGraphics card compatibility: supports new graphics cards shipped after 2015.Application: eGPU for NUC / ITX / STX / Notebook PC (Only supports M.2 NVMe interface, does not support M.2 SATA / M.2 WiFi / M.2 WWAN / USB interface)Note: The length can be customized, if you need it, please contact us. Cable Length Description:R3G series cable length has 25 cm or 50 cm can be selected, the following is the line length of 50 cm. refer to the blue dimension of the figure below.Power Supply Description:Supporting power supply is DELL 8-pin 12V/18A/220W, or standard PSU power supply. The power supply should be prepared by the buyer or purchased separately.Photo:24P_ATX and 4P_CPU power input, 8P_GPU power output.Product accessories, enclosed with the following graphics card power cord belowSW1, Power Forced Start Switch, 1 for automatic startup, 2 for forced startup, please cut to 1 for automatic startup.SW2, PERST # signal delay switch, 1 delay 2.2 seconds, 2 delay 4.5 seconds, with eGPU software, for graphics card compatibility optimization, the current software does not support, please cut to 1SW3, CLKRUN # signal delay switch, 1 is closed, 2 is delayed for 9 seconds, with eGPU software, for graphics card compatibility optimization, the current software does not support, please cut to 1J1, PERST # signal delay switch, OPEN to open delay function, SHORT to close delay function, the current software does not support, please insert the jumper cap SHORT.J2, CLKRUN_Capacitance Delay, currently the software does not support, only for R&D engineers plug in capacitance adjustment delay testing. It takes about 2.2 seconds to insert a 1uF capacitor, 5 seconds to insert a 2.2u capacitor, and so on.Installation steps:1. Install the hexagonal copper pillar and insert the graphics card into the PCIe x16 slot. The screw is tightened so that the graphics card will not shake or fall off.2. Install ATX power supply or DELL power supply, including graphics card power cord should also be connected, after installed, DELL power supply will light orange lights.3. You can plug in the M.2 cable when the computer is off. After power on, the ATX power supply will automatically start the fan to turn. If you use the DELL power supply, the green light will turn on. At this time, the R3G board will turn on two green lights. The system will recognize the card automatically. Please install the graphics card driver. The installation of the driving process may prompt the computer to restart.4. finish.

Price: 42.38 USD

Location: 深圳

End Time: 2024-12-01T08:51:14.000Z

Shipping Cost: 0 USD