Mold Rubber Coating Wall Fake Stone Wall Panel 3D IN Chalk for Concrete

Description: Professional 3d mold, model "Wave" in polyurethane rubber, for maximum precision of the tile made. dimensions of the tile obtained, cm. About 50x50x2.5 tile that can be colored before or after its realization The color of the mold may vary based on availability. Visit our e-commerce www.pietrastampata.com for many other models and accessories! All our professional casting molds are made exclusively of polyurethane rubber, for an excellent reproduction of the fake stone.The polyurethane rubber will allow you to use the mold very easily, does not require the use of release liquids, as it is self-releasing thanks to its flexibility, and will allow you to create numerous square meters, without the mold undergoing signs of wear. . How to make the dough for the casting mold. The preparation of the mixture for the molds depends on the destination, internal or external, of the tiles made.In an indoor place, simply mix rapid chalk powder or alabaster with water, to create a consistency similar to a toothpaste paste.The times for removing the tile from its mold depend on the humidity of the environment in which it will be made, in any case generally within 20-30 minutes.On the other hand, if the place will be external, it will have to be mixed with water, cement powder and sand, generally with a ratio of 1: 3, but the proportions are also variable depending on the humidity of the sand used.In this case, the time required to remove the tile from its mold will be longer, in any case within 12/18 hours, depending on the external temperature.Alternatively, it is possible to use premixed products, used in construction to create screeds. The coloring It is advisable to color the plaster or cement tile after its realization, using iron oxide powders, of at least 2 different shades, to be applied on the tile after the realization (on our e-commerce you will find a wide assortment).Finally, we always recommend using a transparent silicone paint, to further protect the work performed, also facilitating the cleaning operations of the tile. Installation • Use quality premixed glues.• With a notched trowel spread the glue on a limited surface.• Spread a generous layer of glue on the back of each individual stone.• Make the individual stones adhere by applying pressure and at the same time making a right-left movement and from top to bottom, until the glue overflows on each side.• Any burrs must be removed with a spatula.• For the joints it is recommended to use suitable products• After about 30 minutes or an hour (depending on the temperature), when the mixture has hardened, but still wet, scrape the surface of the putty with the brush handle.• With a dry brush, smooth and clean the affected surface.• ATTENTION: do not use wet sponges, water or acid-based products to clean the joints, do not use iron brushes.• It is advisable to treat the entire surface with a transparent water repellent when it is completely dry retractable siloxane type, all to protect the surfaces from dirt and dust. The polyurethane rubber will allow you to use the mold very easily, does not require the use of release liquids, as it is self-releasing thanks to its flexibility, and will allow you to create numerous square meters, without the mold undergoing signs of wear. . On the other hand, if the place will be external, it will have to be mixed with water, cement powder and sand, generally with a ratio of 1: 3, but the proportions are also variable depending on the humidity of the sand used. It is advisable to color the plaster or cement tile after its realization, using iron oxide powders, of at least 2 different shades, to be applied on the tile after the realization (on our e-commerce you will find a wide assortment). • Make the individual stones adhere by applying pressure and at the same time m

Price: 202.56 USD

Location: BARI

End Time: 2024-02-27T17:13:40.000Z

Shipping Cost: 45 USD