ProTek RC 1S High Capacity Sanwa M17 LiPo Transmitter Battery (3.7V/5500mAh) PTK

Description: ProTek RC 1S High Capacity Sanwa M17 LiPo Transmitter Battery (3.7V/5500mAh) PTK-5550 This is the ProTek R/C High Capacity 1S Transmitter Battery with 5500mAh of capacity, for use with the Sanwa M17 Surface Transmitter. This light weight Li-Poly transmitter battery will help to dramatically extend the run time that your transmitter can offer, which is great for long days at the field! How should the battery be inserted into the transmitter?A suitable foam should be used to pad the battery in the transmitter battery compartment to help hold the battery in place and prevent it from moving around. Place a piece similar in size to the battery into the transmitter battery housing under the battery, and then while pressing lightly on the battery, slide the cover over the battery. Specifications: Voltage: 3.7V Capacity: 5500mah Chemistry: Lithium Polymer Connector: JR Charge Rate: 1C Dimension (LxWxH): 79x46.5x12mm Weight: 94g IMPORTANT:1) DO NOT leave the battery in your model when charging2) DO NOT leave unattended when charging3) ALWAYS balance charge the battery4) ALWAYS use a LiPo charging bag5) YOU MUST use a Li-Poly specific charger to charge the pack (NiMH or NiCD only chargers WILL NOT WORK!)6) YOU MUST not over discharge the Li-Poly battery pack7) READ & UNDERSTAND the instructions carefully before operating this batteryNOTE: When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will result in over heated batteries. Discharging capacity can't exceed 80% of the max capacity of the pack after full charging to ensure a good cycle performance. It is recommended to fully charge a brand new battery before using and only discharge the battery 50% for first 5 cycles. Always monitor race time and/or set a low voltage warning on ESC (End voltage cannot be lower than 3.2v per cell). Do not use the battery that has too low a voltage.Do not expose batteries to sunshine or store/charge batteries at the temperature above 35°C or in a closed car. The high temperature environment could cause damage to the pack or make it burst. If the battery becomes hot while fast charging, high current discharging or racing, do not charge the battery until it has cooled completely. Wait about 20 mins, then inspect prior to recharging. ProTek RC 1S High Capacity Sanwa M17 LiPo Transmitter Battery (3.7V/5500mAh) PTK-5550 This is the ProTek R/C High Capacity 1S Transmitter Battery with 5500mAh of capacity, for use with the Sanwa M17 Surface Transmitter. This light weight Li-Poly transmitter battery will help to dramatically extend the run time that your transmitter can offer, which is great for long days at the field! How should the battery be inserted into the transmitter? A suitable foam should be uséd to pad the battery in the transmitter battery compartment to help hold the battery in place and prevent it from moving around. Place a piece similar in size to the battery into the transmitter battery housing under the battery, and then while pressing lightly on the battery, slide the cover over the battery. Specifications: Voltage: 3.7V Capacity: 5500mah Chemistry: Lithium Polymer Connector: JR Charge Rate: 1C Dimension (LxWxH): 79x46.5x12mm Weight: 94g IMPORTANT:1) DO NOT leave the battery in your model when charging2) DO NOT leave unattended when charging3) ALWAYS balance charge the battery4) ALWAYS use a LiPo charging bag5) YOU MUST use a Li-Poly specific charger to charge the pack (NiMH or NiCD only chargers WILL NOT WORK!)6) YOU MUST not over discharge the Li-Poly battery pack7) READ & UNDERSTAND the instructions carefully before operating this batteryNOTE: When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will result in over heated batteries. Discharging capacity can't exceed 80% of the max capacity of the pack after full charging to ensure a good cycle performance. It is recommended to fully charge a brand new battery before using and only discharge the battery 50% for first 5 cycles. Always monitor race time and/or set a low voltage warning on ESC (End voltage cannot be lower than 3.2v per cell). Do not use the battery that has too low a voltage.Do not expose batteries to sunshine or store/charge batteries at the temperature above 35°C or in a closed car. The high temperature environment could cause damage to the pack or make it burst. If the battery becomes hot while fast charging, high current discharging or racing, do not charge the battery until it has cooled completely. Wait about 20 mins, then inspect prior to recharging. × Buy now and save! Tell a friend Visit store Watch now Postage info Click the Postage tab above the listing description for more info We will combine shipping. Please request an Invoice or message us after purchase to adjust shipping charges. Additional delivery notes PICK UP OPTION Sorry, our items are NOT available for pick-up. PAYING VIA PAYPAL We accept PayPal on our all our items so you can shop with confidence. Simple choose the PayPal option when proceeding through the checkout. Additional Information No additional information at this time Ask seller a question You might also like Rakon CNC AL Propeller Guards (Green) - Blade Inductrix 31mm Rakon CNC AL Propeller Guards (Orange) - Blade Inductrix Rakon CNC AL Propeller Guards (Purple) - Blade Inductrix Rakon CNC AL 6mm Motor Mount Set - Blade Inductrix IDTX601 Contact To contact our Customer Service Team, simply click the button here and our Customer Service team will be happy to assist. Ask seller a question © Excel RC Postage Click the Postage tab above the listing description for more info We will combine shipping. Please request an Invoice or message us after purchase to adjust shipping charges. We do not ship to freight forwarding companies, we will not be responsible for any shipments once our tracking number shows the first delivery scan. Payment Accepted Payment Methods PayPal eBay Payments Returns Returns are accepted Items must be returned within 30 days of the auction ending Seller will pay for return shipping. Additional Information: Returns Accepted, Buyer, 30 Days, Money Back, International: Returns Accepted, Money back or replacement (buyer's choice), 30 Days, Buyer eBay integration by

Price: 57.99 USD

Location: Garden City, Michigan

End Time: 2024-11-13T20:24:46.000Z

Shipping Cost: N/A USD