Three-phase 0-5V RC control 30A LKBS48501 controls 48V 1KW brushless servo motor

Description: Three-phase 0-5V RC control mode 30A LKBS48501 controls 48V 1KW brushless DC servo motorLKBS48501+LK110BS0410-15Products DescriptionWhat is a Brushless DC motor (BLDC)?Brushless DC motor (known as BLDC) is a permanent magnet synchronous electric motor which is driven by direct current (DC) electricity and it accomplishes electronically controlled commutation system (commutation is the process of producing rotational torque in the motor by changing phase currents through it at appropriate times) instead of a mechanically commutation system. BLDC motors are also referred as trapezoidal permanent magnet motors. It has no mechanical commutator and associated problems High efficiency due to the use of permanent magnet rotor High speed of operation even in loaded and unloaded conditions due to the absence of brushes that limits the speed Smaller motor geometry and lighter in weight than both brushed type DC and induction AC motors Long life as no inspection and maintenance is required for commutator system Higher dynamic response due to low inertia and carrying windings in the stator Less electromagnetic interference Quite operation (or low noise) due to absence of brushesProduct ParamentersMotor size:Motor Controller Product Features: Wide-range voltage input, 10-55V.  Intelligent PID control loop.  Working mode: Speed open-loop, close-loop control, torque close-loop control, position close-loop control.  External potentiometer, 0-5V analog quantity or pulse command control mode, RC (pulse width signal outputted by the receiver of aeromodelling remote control) control mode.  Safety forward & reverse control, four-quadrant operation, support regeneration.  Enable control function.  Maximum current control.  4-way input port; the function can be defined as analog input, pulse input or digital input functions.  2-way digital (MOS tube open-drain) output, Generally as 24V 1A output  (maximum load capacity of 40V 1A), can be used to loosen the brake or  other attachments.  Abnormalities like overcurrent, overheating, overvoltage and short circuit will start the protection function.  LED status indicator.  CAN bus communication, see the detailed communication protocol when using it RS232 communication, see the detailed communication protocol when using it.At the ambient temperature 25℃, continuous working current 30A, transient current up to 75A 30S. Out+5VDC power (It can power up the encoder): 5V DC 20mA Analog input range: 0-- 5VDC Impulse input range: 500Hz—5000Hz (corresponding maximum speed) [Note] The minimum impulse frequency may change along with the setting of maximum speed. Input range of duty ratio 0%-- 100% (input frequency range f ≤1KHz, recommend to use the frequency of 250Hz). the digital output interface: 2 road, open drain, maximum load capacity of 40 V 1 A Temperature protection status: When the temperature is 70℃, the controller will reduce output by overheating protection and will stop output when the temperature is 80℃. Working temperature: -30℃-- +60℃. Ambient humidity: Relative humidity≤80RH. Boundary dimension: L * W * H = 148mm * 117mm * 40mm Weight: 800gProduct packaging

Price: 342 USD

Location: Jinan

End Time: 2024-12-25T08:00:01.000Z

Shipping Cost: 90 USD