Tigertronics SLUSB8R Signalink USB FOR 8-PIN, ROUND TYPE MICROPHONE JACK

Description: SLUSB8R SignaLink™ USB SLUSB8R FOR 8-PIN, ROUND TYPE MICROPHONE JACK This listing includes the following items: SignaLink USB Detachable 8-pin Round Type Mic Radio cable p/n SLCAB8R (1.5ft length) Detachable USB Cable (6ft length) Jumper Wires (set of 6, cut and stripped, and ready to use - NO soldering required!) If you do not want to install jumper wires, then be sure to see our Plug & Play Jumper Modules. They greatly simplify installation! Printed Manual Allen Wrench Rubber Feet The SignaLink USB supports virtually all sound card digital and voice modes including FT8, PSK31, JT65, WINMOR, Winlink Express, VARA FM 1200, RTTY, SSTV, CW and EchoLink, to name a few. The SignaLink USB p/n SLUSB8R is compatible with virtually all Alinco, Elecraft, Icom, Kenwood and Yaesu radios that an 8-pin round type microphone jack. This includes but is not limited to the radios listed below. NOTE: Some of the radios listed below also have a Data Port or Accy Port that the SignaLink can be connected to. If this is an option on your radio (check your radio manual or ask us) then it would normally be preferred since this would allow you to connect the SignaLink to the back of the radio and keep your microphone plugged into the front. Please see our other eBay listings for Data/Accy cable options or ask us if you need a cable that is not listed. If your radio is not listed below then be sure to check our other listings or contact us. We have a number of different SignaLink part numbers available to fit most standard radios. The SignaLink USB comes with all of the cabling needed to use it with your computer and radio (see below for a list of compatible radio models), as well as sample software to get you started. Compatible Alinco Radios -- SLUSB8R ALD-24T ALR-22T ALR-22HT ALR-72T DR-110T DR-112T DR-130T DR-135E DR-135T DR-150 DR-235T DR-430T DR-435E DR-435T DR-510T DR-570T DR-590T DR-592T DR-599T DR-600T DR-610E DR-610T DR-620E DR-620T DR-635 DR-1200 DX-70 DX-70T DX-70TH DX-70EH DX-77 DX-SR8T/E DX-SR9 Compatible Elecraft Radios -- SLUSB8R Elecraft K2 Elecraft K3 Elecraft K3/S Compatible Icom Radios -- SLUSB8R IC-22U IC-25 IC-27 IC-28 IC-37A IC-38A IC-45 IC-47 IC-48 IC-228 IC-229 IC-251AE IC-255 IC-260 IC-271 IC-290 IC-375 IC-471 IC-475 IC-490 IC-505 IC-551 IC-560 IC-575 IC-707 IC-718 IC-720 IC-725 IC-726 IC-728 IC-729 IC-730 IC-735 IC-736 IC-737 IC-738 IC-740 IC-745 IC-746 IC-746PRO IC-751 IC-756 IC-756PRO IC-756PROII IC-756PROIII IC-761 IC-765 IC-775 IC-781 IC-820H IC-901 IC-910 IC-1201 IC-1271 IC-1275 IC-2400 IC-2500 IC-3200 IC-3210 IC-3220 IC-3230 IC-7400 IC-7410 IC-7600 IC-7700 IC-7800 IC-9100 Compatible Kenwood Radios -- SLUSB8R TM-201 TM-211 TM-221 TM-231 TM-241 TM-321 TM-331 TM-401 TM-421 TM-431 TM-441 TM-521 TM-531 TM-541 TM-621 TM-631 TM-701 TM-721 TM-731 TM-2530 TM-2550 TM-2570 TM-3530 TR-50 TR-751 TR-851 TS-50 TS-60 TS-140 TS-430 TS-440 TS-450 TS-570 TS-590 TS-660 TS-670 TS-680 TS-690 TS-701 TS-711 TS-780 TS-790 TS-811 TS-850 TS-870 TS-930 TS-940 TS-950 TS-990 TS-2000 TW-4000 TW-4100 Compatible Yaesu Radios -- SLUSB8R FT-1 FT-102 FT-107 FT-107M FT-290 FT-707 FT-726R FT-736 FT-736R FT-747 FT-757 FT-757GX FT-767GX FT-840 FT-847 FT-890 FT-920 FT-950 FT-980 FT-990 FT-1000 FT-1000D FT-1000MP FT-DX1200 SignaLink Features FCC Certified - Unlike virtually all of our competitors, the SignaLink USB has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. Built-in Low Noise Sound Card - This provides optimum performance and frees your computer's existing sound card for other uses. It also greatly simplifies installation and operation, by reducing the number of cable connections, and by providing consistent performance that is independent of the computer's sound card. Simple Installation - The SignaLink USB has only one USB connection to the computer, and in most cases, only one connection to the radio*. There are no computer audio cables to get mixed-up! Easy Setup and Operation - The SignaLink USB's built-in sound card provides consistent audio levels and performance that is completely independent of the computer's sound card. This lets us streamline our Audio Level Setting procedure like never before. Simply set the software "Transmit" audio controls as described in the SignaLink manual, and then adjust the SignaLink's front panel "TX" control for the desired RF power level. Setting of the RX Level is even easier, as this is done completely by the SignaLink front panel "RX" control. There are no software "Recording" controls to adjust! Convenient Front Panel Controls - You can now easily adjust your TX Audio, RX Audio and Transmit Delay without having to open the SignaLink case. This lets you optimize your Transmit Audio (RF Power), Receive Audio level ("waterfall drive"), and Transmit "Hang Time" delay "on the fly"! Works with virtually ALL Radio Mic, Data, and Accessory Ports - The SignaLink USB works with virtually ALL radios, and can be attached to your radios Mic, Data, or Accessory port. This allows most users to attach the SignaLink to the back of the radio (Data or Accessory Port) and leave the microphone plugged in! Supports virtually All Sound Card Digital & Voice Modes - The SignaLink USB supports virtually ALL Digital and Voice modes that are available for sound card interfaces. This includes traditional modes such as CW, RTTY, AMTOR, and SSTV (to name a few), and virtually ALL new modes such as FT-8, JT65, PSK-31, MT-63, WINMOR, VARA FM 1200, and EchoLink. Virtually ALL standard sound card communications programs will work with the SignaLink USB. Complete Isolation - Unlike some interfaces on the market, ALL SignaLink models COMPLETELY isolate your computer from your radio. This eliminates troublesome ground loops and prevents hum and noise from degrading the signals. The SignaLink USB provides isolation through the use of audio transformers and a relay-based PTT keying circuit. Transmit Audio / "Side Tone" Output - A rear panel "Monitor" jack can be used with headphones or powered (amplified) speakers to monitor your Transmit Audio, or Side Tone during CW operation. External Speaker Support - If your installation requires that you attach the SignaLink to your radio's External Speaker jack, then you can plug an external speaker or headphones into the SignaLink's rear panel "Aux" jack and continue to hear your RX Audio. No External Power Required - The SignaLink USB is always powered by the computer's USB port, so external power is NEVER required. Every SignaLink USB is supplied with the following items: Fully Assembled Detachable Radio Cable - The SignaLink part number determines which radio cable is supplied with the unit. USB Cable - This cable connects the SignaLink USB to your computer. It is approximately six feet in length. Jumper Wires - These are used to configure the SignaLink for your specific radio. No soldering is required - The jumpers simply push into a socket on the circuit board! The SignaLink software CD contains jumper settings for the most popular radios. Settings for other radios can be easily obtained by following the step-by-step procedure in the SignaLink manual, or by contacting our Technical Support Staff. If you do not want to install jumper wires, then be sure to see our Plug & Play Jumper Modules. They greatly simplify installation! Allen Wrench - 3/32" size. Used to open the SignaLink USB case. Rubber Feet - These are included with every SignaLink USB and can be installed by the user if desired. Printed Installation Manual - The SignaLink manual contains both step-by-step, and "quick" installation instructions for users of all experience levels. Troubleshooting Tips and an Audio Level Adjustment procedure are also included. SHIPPING AND FEEDBACK ALL OF MY LISTINGS ARE NEW, IN THE BOX, IN STOCK AND READY TO BE SHIPPED. I don't list items that are not in stock or items that will be shipped from another location (drop shipped). I don't sell used or refurbished equipment. I ship 6 days per week and use the United States Postal Service for Saturday deliveries. Item will ship same day or next day after payment is received, depending on the time of day payment is received. Feedback will be left the same day or next day after payment is received. I LEAVE FEEDBACK AS SOON AS I PRINT THE SHIPPING LABEL!! Shipping will be USPS with Delivery Confirmation tracking. You will receive a email with the tracking number when the package ships.

Price: 139.95 USD

Location: Summitville, Tennessee

End Time: 2025-01-20T21:22:42.000Z

Shipping Cost: N/A USD